Go to bottom and select ‘Z-Wave Utilities’
Add hub back to your account using 1 time code (that can be used more than one time ) Go to locations in the app and in the setting remove the location where you hub is located. Reset Controller *This will wipe all z-wave devices but leave everything 2-Gig from Vivint in place. BTW 2203 is default for their control panels. Reset Sky Controller z-wave mesh in installer toolbox (have installer code). It took me quite a few tries to get it right, but I believe I have most all devices working.
However, we are always looking at expanding our home automation products, and there are several items on the horizon that we want to introduce to give everyone more home automation selections. This ultimately would defeat the purpose of it sadly enough. Good afternoon and thank you for reaching out to us today! At this time, we could not use the SmartThings hub as a secondary controller, it would pair to the system since it goes off the ZWave network but there would be no remote control, schedules or rules since it wouldn’t be recognized by the infrastructure of the website or mobile app. As a newbie on this, I decided to ask the FrontPoint tech guys about it. I stumbled on this thread and read through it. I just want to take info from The FrontPoint sensors into SmartThings to help with light and switching decisions/actions as I expand my system. Not interested in feeding the other way (don’t want to mess up the security functions and reliability). While working through the above, I started thinking about a one-way (only) integration/use of my FrontPoint’s sensors by SmartThings.
Installer toolbox code vivint software#
There’s currently a known SimpleControl software issue that’s preventing me from setting up the integration, but when it’s fixed in the next release, I should(?) be able to use the Echo to control my AV System and allow SimpleControl to control SmartThings too I also started to integrate the SmartThings hub with my SimpleControl (was RoomieRemote) A/V and HomeAutomation controller. So, I recently bought a SmartThings hub to start the process of replacing the X-10 equipment a room at a time.Īt this point, I have set up one room with a motion sensor and five LED/controllable lights, integrated the SmartThings hub with my Amazon Echo for voice commands - for what little I have currently. Although that’s been very reliable, as more noise finds it’s way to electric lines, one of my rooms was less reliable than before. I’ve also been using X-10 for lighting routines, etc. I have FrontPoint as my home security provider using a GE Simon as the console/Z-Wave Controller. The only way I see the door is unlocked is by using the app and refreshing it’s status. For example, unlocking doors, the 2gig doesn’t appear to get notified that it has unlocked. But, 2gig will not (from what I can tell) get stateful data back from the devices without polling them. Both can send out commands to the devices, so, rules on 2gig, or on ST will both work. Not sure if anyone else has had that working, so, the 2gig disarms when the door is unlocked by a user code?Īs for actions on the 2gig from ST, I don’t believe that’s possible. From what I can tell, there is no way to have that work as of right now. Therefore, I unlock the door with my usercode, only the smartthings hub is aware of that. I think with the smartthings being the primary device, it does not provide stateful data back to the 2gig. The one thing that doesn’t work is I used to have a rule that when the door lock was unlocked by a user code, it would disarm the system. I have a few rules turning lights on/off at certain times. I got the rules with functioning again with their help.
0 kommentar(er)
